Supply APY vs borrow APY: why your deposit earns less
Why is supply APY lower than borrow APY in DeFi lending? Utilization and the reserve factor explain the gap, and a simple formula estimates what suppliers earn.
The Today Crypto Editors

Supply APY is lower than borrow APY in a lending pool because borrowers pay interest on the funds they use, while suppliers share what remains across all deposits. In SparkLend, a permissionless market where users lend assets and borrow against supplied collateral, utilization and the reserve factor determine that gap.
For you, the difference is a pool calculation: the borrow rate alone does not tell you what your supplied asset earns.
Utilization and the reserve factor reduce the supplier rate
A pool takes in borrow interest, scales it by utilization, then sends the portion left after the reserve factor to suppliers. In Aave V3-based markets, the estimate is: supply APY = borrow APY × utilization × (1 − reserve factor), ignoring compounding differences.
Utilization is the share of supplied funds that borrowers have taken out. If 80% of deposits are borrowed, utilization is 80%. The remaining 20% is idle: it earns no borrow interest, but it is still part of the supplied pool over which interest is shared. That dilutes the rate earned across all deposits.
The reserve factor takes another cut. It directs a share of borrow interest to the protocol treasury before the rest reaches suppliers. So even when most funds are borrowed, suppliers receive less than borrowers pay if the reserve factor is above zero.
SparkLend uses this Aave V3 formula, which makes its lending rates a concrete example of how utilization and the reserve factor shape supplier returns. Each reserve, such as DAI or WETH, has its own utilization and reserve factor, so the rate gap can differ by asset.
At full utilization, zero reserve factor is the only route to equal rates
If the reserve factor is zero, suppliers still earn less than borrowers pay whenever utilization is below 100%. Idle deposits reduce the average supplier rate even though they earn no borrow interest themselves.
At 100% utilization, every supplied unit is borrowed, so there is no idle share to dilute the interest. With no reserve-factor cut, supply APY can equal borrow APY. But this is also the point where the pool has no unborrowed funds available for suppliers to withdraw immediately. The equal rate comes with no available liquidity.
A simple estimate shows how the gap works in practice
Say you supply an asset to a pool with a 5% borrow APY, 80% utilization and a 10% reserve factor. First, utilization scales 5% to 4%. Then the reserve factor leaves suppliers 90% of that interest: 4% × 0.9 = 3.6%. The estimated supply APY is 3.6%.
Nothing about the 5% borrower rate changed in this calculation. The 80% utilization means only that share of supplied funds generates borrow interest; the 10% reserve factor means the treasury receives part of that interest. The remaining amount is shared across suppliers. This is a pool-level estimate, and compounding can create small differences between the displayed APY and the simplified calculation.
Related questions
What is the utilization rate in DeFi lending?
Utilization is the share of a pool’s supplied funds that borrowers have borrowed. A higher rate generally means more of the pool is earning borrow interest and less liquidity is sitting idle for withdrawals.
Why do lending rates change every block?
Rates can update as pool activity changes utilization: borrowing uses available funds, while repayments return them. The rate model determines how those state changes affect rates; its curves are outside this explanation.